if they are over the handle bars, sitting back in the seat, sitting to the side of the seat, etc.) Individual aspects can also change how a ski handles from one rider to the next, these can include: While some people prefer the ski to act and handle one way, others may want it to react entirely differently. The paddles then can be adjusted to give you more or less of a complete turn, affecting the entry, mid and exit of the corner. The width or height of the backing rail will also be noticed through the middle of the corner and affects whether the ski will stand up too much and want to roll out, or if it has a more neutral turn.
Inversely, the the wider the backing rail is, or the lower it's positioned, the more initial turn the ski has. This is the same as not using the spacer on any model that includes a space as well. So the higher the backing rail position is the more it will roll so that the first turn of the ski will take a little longer. The overall height of the backing rail will determine how far the ski can roll into the corner. It's best to have an idea of what you want out of the ski before installing the sponsons and adjust as close to that. Sponson positioning greatly depends on the rider and the ski.
I offer full money back guarantee if not satisfied for any reason.How should I position my sponsons on my ski?
The TrimFix is not only a Repair Solution, it is also an upgrade for your Seadoo. Trimfix installation is simple No special tools needed, full illustrated instructions included The Trim Fix is not only a Solution, It is an Upgrade! The Trimfix control module and gauge position sensor both mount externally of the VTS housing so the housing never even needs to be removed making the TrimFix kit even more desirable. The TrimFix eliminates all of this by replacing the failed electronics that are in the VTS Housing and never even having to remove the VTS Housing. And of course a new VTS Housing is over $300.00 and and it would be lucky if it lasted more that a couple seasons before it failed as they always do. The original module and gauge position sensor electronics are located internally within the VTS housing and are non-serviceable, so when failure occurs, the complete VTS housing must be replaced which requires special tools, and if the repair is not done correctly, water will enter the hull and a catastrophic failure to the craft can occur.
You don't even need to remove your vts housing to install the Trimfix. The TrimFix is an easy to install module and sensor that replaces the failed electronics inside the vts housing and eliminating the need to replace your vts housing. With TheTrimFix you will never again replace a bad VTS Housing.
VTS housing failure is an extremely common occurrence, and they are too expensive to keep replacing all the time.
The TrimFix includes sensor, at no additional cost, to restore gauge operation "Don't waste another penny replacing another failed VTS Housing!" With the TrimFix, there's no need to to replace or even remove your VTS Housing at all! This kit is the SOLUTION for Seadoo trim VTS Housing failure. The TrimFix uses your original factory switch and gauge for a clean install with no unsightly aftermarket addons or alterations Another result of VTS housing failure is the gauge stops working due to the sensor being inside the VTS housing. Item: 233632149123 Seadoo VTS Housing Trim Module and gauge sensor SOLUTION.